How to operate the hot stamping die cutter safely?

Stamping die cutting machine is a kind of stamping die cutting machine that can be used for stamping die cutting. Stamping machine stamping is to heat the die to a certain temperature and print a pattern or font with three-dimensional effect on the surface of the printed product. Next, to understand the hot stamping die cutting machine safety operating procedures.

1,Before starting each shift, we must carefully check whether the brake button, stop button, foot switch and safety device are sensitive and reliable, check whether each protective device of the machine is sensitive and tight, and whether there is a blockage phenomenon; Check whether there is debris in the operating part of the machine, so as not to affect the safe operation of the machine. It is strictly forbidden to remove or modify the foot switch, safety device or protective rod without permission, so as not to cause safety accidents.

2, check whether the machine running sound is normal, flywheel operation is stable, brake system is sensitive, safety protection device is flexible and reliable. The control switch on the machine should be flexible and stop quickly; Transmission mechanism action should be accurate, coordination without error; Lubricate the equipment regularly every shift;

3, When installing the hot stamping plate, the prepared plate should be installed and calibrated on the heating plate according to the hot stamping position of the product and fixed before it can be started and adjusted;

4, debugging pressure should be in line with the principle of light after heavy gradually adjust the pressure of hot stamping die cutting machine, adjust, test hot, until hot printing uniform, firm, up to the quality standard so as to avoid excessive pressure and crush the iron plate, hot stamping board or damage to the machine;

5, in the debugging and hot stamping process must tighten the bottom plate screws, so that the iron plate stable before starting production;

6, When replacing the electrolytic aluminum or adjusting the knife plate, you need to extend your hand to the movable body or the machine, you must stop the machine, turn off the working power, and so on, the flywheel can be completely stopped before causing unnecessary damage.

7, When replacing electrolytic aluminum, pay attention to the high temperature of the electric heating plate and the rear bed body, and the possibility of burns in direct contact with the human body, it should be replaced after cooling.

8, the steel roll or rubber roll has the possibility of rolling into clothes and hair, should not be close to the steel roll or rubber roll when working, so as not to cause personal safety

9, If the printing sheet is not placed or not taken out in time during the hot stamping process, it should be stopped quickly or pulled down the air pressure handle to avoid waste products. During operation, to ensure personal safety, do not grab and release.

10, When loading, correcting, adjusting the gauge distance and adjusting the pressure, the working power supply should be turned off, and it can be carried out after the flywheel stops rotating. It is strictly forbidden to board and adjust the plate when the working power is turned on and the flywheel is running, to prevent the occurrence of pulley or other accidents and to avoid personal, equipment or property safety accidents.

11, when operating, the operator should stand in front of the active plate, the operator is strictly prohibited to stand on both sides to take paper or put paper, is strictly prohibited to chat with others.

12, operation, should often pay attention to the operation of the machine, such as abnormal situation or emergency should be stopped in time, shut down the power and notify the supervisor or adjustment, until the machine repair personnel to confirm that there is no problem before starting production;

13, often pay attention to and keep the machine clean, regular maintenance.